Vanilla Fox Spec

[V2 - Italy]

Is there anyone that is willing to share the force vs. velocity graph, of the Vanilla RC dampers?

We'd like to use these dampers but we have no data to complete our design.

Daniele

Firenze Race Team V2
http://www.firenzerace.too.it
DUCATI POWER at the UniversitÃ* di Firenze

[V2 - Italy]

Is there anyone that is willing to share the force vs. velocity graph, of the Vanilla RC dampers?

We'd like to use these dampers but we have no data to complete our design.

Daniele

Firenze Race Team V2
http://www.firenzerace.too.it
DUCATI POWER at the UniversitÃ* di Firenze

[RichE]

We are about to try and dyno test an old fox vanilla rc shock, at the moment setting up the dyno is proving difficult but we should have some data in the next couple of weeks.

Rich

Cardiff Uni
FS Team Manager

[Bulldog R]

We are also planning to use the RC's and would appreciate seeing some dyno data when you get it. Good luck with the tests

[Jarrod]

we have a graph of force vs velocity from our vanilla RC's with soft, intermediate and hard settings, can email it if you want.

jpham1@student.monash.edu.au

[Bulldog R]

Jarod,

I would appreciate the data on the RC's

Thanks,
Joe Ojeda
jco18@csufresno.edu

Bulldog Racing
CSU, Fresno
www.csufresno.edu/IndTech/SAE

[Aaron Harnden]

Jarrod,
I too would appreciate the data on the RC's if you're willing to help out a fellow Victorian

harnden@deakin.edu.au

Aaron Harnden
Phantom Engineering
Chief Design Engineer 2004

I may not always be right, but i'm never wrong...