Questions and discussions about Cost Analysis, Design, and Presentation.
Hey, Reaction Tool <= 25.4 mm In the above process given i:rolleyes:n tables is 25.4 mm diameter of nut to be installed or length of...
Hi every body ,we are first year team and we want to take part in Japan Formula SAE ,We have some problem in ses filling,some of things are mule: we...
Hello Guys Im Sud , I had a doubt regarding the cost report. Q. Under tooling for welds - Welding Fixtures , the unit cost is $500 per point...
Hey everyone. All right so I've been trying to find an answer to my simple question hunt through the forums, but I can't. It's probably a very simple...
Hi according to the T.3.22.1 rule we can use Quasi-static test for impact attenuator. Is that true ? If it's true, what is the parameter for test...
Heyy Guys, We are using polyurethane in our Front ARB. Can someone tell me which material from the tables given I have to use for polyurethane ?:)
Hi, In FCA_Inputs files are we committed to use "Cross section" sub sheet list? If yes,are we only limited by the values in this sheet or we...
The picture below shows the frame of our car and I want to know if the section shown is against the rules or not. Could anyone help?
I was wondering if the SES form is required for all teams even if all rules are followed. Would drilling holes into the main roll hoop or other...
This is a "heads up" for FSAE-EV and FH teams. On the afternoon of Saturday, March 29th, the SAE Detroit Section is going to have a 1/2 day...
Hi guys! i'm compiling the structural equivalency spreadsheet and i have a problem in the "welded tubes" tag. what does this tag refer to? in the...
Hi, It is my first post here therefore I will first introduce myself. My name is Luka Jerman and I am a member of University of Maribor Formula...
Hi all, I've got two question regarding the new Monocoque additions to the 2014 Structural Equivalency Spreadsheet (SES) 1st Question: How...
Until now, we listed the step "cut (scissors, knife)" for each fibre layer or mat. Accordingly, we needed more material (cutoff) and more labor. When...
Hi, According to 2013 FSAE rule S4.5 cost reports were planned to be published after the end of calendar year. I appreciate this approach as I also...
Do we have to use assembly process (line on line, loose, interference) while installing a retaining ring in a wheel bearing. If yes which one ?
The SAE’s Motorsports Engineering Committee and the Indiana Section of SAE-I will be hosting another Collegiate Roadshow in conjunction with the...
Rule T3.7.1 says: Minimum Wall Thickness: Aluminum Tubing 3.0 mm (0.118 inch) The rule is in the chassis chapter, alternative frame rules chapter....
For the 12th year, the SAE Detroit Section will be hosting its annual Formula SAE Workshop at the University of Michigan-Dearborn campus on Saturday,...
Hello How can I measure the needed force to make the drum rotate , for Honda CBR600rr engine . And thank you so much. Ahmad
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules