Would it be possible to have some of these tutorials in the form of literature and get a PDF/eBook going?
Would it be possible to have some of these tutorials in the form of literature and get a PDF/eBook going?
Here is the latest video covering fatigue analysis on SolidWorks simulation:
http://www.youtube.com/watch?v=vUyIm-w9YAo&fmt=22
@BMH We are definitely looking at doing that. I can't say for sure what the final result will be, but something is in the works.
Is there a whitepaper detailing the fatigue solution methods so that this can be compared to other packages?
Chris, here is a start:
http://www.solidworks.com/sw/d...eAnalysis_WP_ENG.pdf
I'll contact the simulation team and see if they can provide any more information
I think one of the more challenging aspects of CAD in FSAE development is good exhaust design. Getting the right cylinder pairs, weaving the tubes through the chassis given standard bend radii and keeping close to constant lengths among the exhaust routes.
Would be interesting to see how the official SW crew go about that.
+1I think one of the more challenging aspects of CAD in FSAE development is good exhaust design. Getting the right cylinder pairs, weaving the tubes through the chassis given standard bend radii and keeping close to constant lengths among the exhaust routes.
Would be interesting to see how the official SW crew go about that.
--------------------------------
Prototype Sports Car Design Blog
Miami University FSAE Chassis Team 2005-2007
Miami University FSAE Suspension Leader 2007-2008
+1 </div></BLOCKQUOTE>Originally posted by alumasteel:
<BLOCKQUOTE class="ip-ubbcode-quote"><div class="ip-ubbcode-quote-title">quote:</div><div class="ip-ubbcode-quote-content">I think one of the more challenging aspects of CAD in FSAE development is good exhaust design. Getting the right cylinder pairs, weaving the tubes through the chassis given standard bend radii and keeping close to constant lengths among the exhaust routes.
Would be interesting to see how the official SW crew go about that.
+1000
SAE @ University of Central Florida
Random 08-09
Team Leader 09-10
Electrical Lead 10-11
Electrical Lead 11-12
Use a sweep. Just set up equations the control the lengths and use linked values for the radii to keep them all the same. From there it's just a matter of routing it through the chassis with 3D sketches.
Billy Wight
University of California, San Diego - Formula SAE 2004-2006
Easier said than done, though I've managed to get it to work like that.Originally posted by billywight:
Use a sweep. Just set up equations the control the lengths and use linked values for the radii to keep them all the same. From there it's just a matter of routing it through the chassis with 3D sketches.
At least the last time I tried it... the 3D sketches got very touchy at times.
"Allright.. now I just gotta make these two tangent... FUCK! It looped out to infinity and back on itself again!" After a significant amount of screwing around you could usually get it to work, but no matter what it took a fair amount of time.
I kinda think it would be nice if you could "move with triad" on sketch points or entities in 3D sketches. There are times when entering the X,Y,Z co-ordinates doesn't do anything.
Right click on the point and select "Show Sketcher Triad"I kinda think it would be nice if you could "move with triad" on sketch points or entities in 3D sketches.
Billy Wight
University of California, San Diego - Formula SAE 2004-2006