+ Reply to Thread
Results 1 to 5 of 5

Thread: Help with tire testing

  1. #1

    Help with tire testing

    Hello everyone or anyone,

    Some years ago a read a post about tire testing with a trailer rig (tire dynamometer).

    It tested slip angle vs lateral force.

    The procedure was really well explained

    I have been looking for it for the past week and can't seem to find it.
    Can anyone give me a hand

    Much appreciated!
    Last edited by Tincho; 05-10-2016 at 01:48 PM.
    ITBACompeticion
    FSAE TEAM 2011
    Tires & Suspension

  2. #2
    Senior Member
    Join Date
    Mar 2008
    Location
    Brighton, MI
    Posts
    686

    Google it and read the PDF File.

    Journal of Materials Science and Engineering A 1 (2011) 616-626
    Formerly part of Journal of Materials Science and Engineering, ISSN 1934-8959

    Design, Construction and Validation of a Portable Tire Test Rig

    Brad Hopkins1, Derek Fox2, Josh Caffee3, Bryan Sides4, William Burke5, Michael Craft1 and Saied Taheri1
    1. Department of Mechanical Engineering, Virginia Polytechnic Institute and State University, Blacksburg, VA, USA
    2. Magneti Marelli, Sanford, NC, USA
    3. General Motors, Milford, MI, USA
    4. Force Protection Industries, Inc., Ladson, SC, USA
    5. Marine Advanced Research, Inc., Richmond, CA, USA
    Received: March 04, 2011 / Accepted: April 12, 2011 / Published: October 10, 2011.
    Abstract: Tire force and moment testing is a valuable way of quantifying the performance of a tire. The data collected from such
    testing is also used by many researchers for vehicle dynamic simulation studies as well as chassis control system development.
    Although various studies have claimed correlation between data from rolling road type machines and road testing trailers, the claim
    only extends for on-road conditions. Many military vehicles as well as agricultural vehicles operate in an environment which requires
    new levels of tire test data. This paper will discuss the design and testing of a portable trailer tire test rig. This rig was conceived and
    constructed for use on both on- and off-road driving surfaces and is also fitted for wet-road testing. The rig will eventually be used to
    collect tire data on various tire sizes both on and off-road on various road surfaces, such as grass, asphalt, concrete, and gravel for
    varying speeds, pressures, loads, and slip angles. The data will be used to develop a modified Pacejka Magic Formula Tire Model that
    can be used for conducting simulation in both on and off-road conditions.

  3. #3
    Senior Member
    Join Date
    Mar 2008
    Location
    Buffalo, NY USA
    Posts
    340
    Bill, Do you know if this Virginia Tech trailer is still in use? Last I heard it wasn't being used very often, but that was several years ago.
    -- Doug

  4. #4
    Senior Member
    Join Date
    Mar 2008
    Location
    Brighton, MI
    Posts
    686
    Nope. I'd tell them to starin gauge a brake rotor as Toyota shows in a paper they wrote on it.

  5. #5
    Thank you very much Bill!!
    ITBACompeticion
    FSAE TEAM 2011
    Tires & Suspension

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts