This thread is just my thoughts so far. This is my first year in FSAE.
The engine we're using is a 2008 Yamaha R6. The engine runs with the stock ECU and aftermarket fuel pump. We revved the engine up to only 8000 rpm since we only had the primary fuel rail connected. We have a Land&Sea engine dyno.
This is where I come in. I'm brand new to ECUs and was basically handed the Motec M84 to make it work. We've got the wiring diagram done, DTM connectors, and the injector and coil sub harnesses completed.
By the end of the week we should have the ECU connected to the engine and will start off with calibration. I'm writing all this since I haven't seen a thread that documents a rookie's experience in FSAE. Thoughts and suggestions?