PM Sent
Thanks
Type: Posts; User: Screaming V8
PM Sent
Thanks
Dan,
To be honest, I would not spend too much time doing the transient simulation in Solidworks. The Solidworks flow sim is not known to give the best results which is why I (as well as others)...
Check it with a timing light while cranking the motor. Set the temporary value in motec to 0 deg (TDC) and the crank the motor with a timing light attached. The timing light should show if it is on...
Use this. http://www.motec.com/downloads/downloadseminars/ This should help you out on most of the motec stuff you need to set up. What specifically in the setup are you having issues with?
I second the fact that the LSU 4.9s are a lot easier to kill, we have killed one so far, and I attribute it to being left to heat more than necessary. In motec there are 2 settings, normal and fast...
Since fuel economy is becoming more of a factor, I would suggest you move to a really small engine. I would say single cylinder since that is what everyone else is doing. I personally would...
Doing a simple search of "Adams tutorial" in this forum will give you all the information you need.