Are they running the FSC and FSE endurance together?
 |
|
|
|
|
|
|
|
Type: Posts; User: Shebert
Are they running the FSC and FSE endurance together?
Life is not just about hard work.
- re-read the rules
- check over the tech inspection checklist
I've seen picture of a plywood/fiberglass chassis from ETS. I think it was the first FSAE from ETS, but I'm not sure if it competed.
Maybe some of the new guys can post the picture, it must be...
http://fsae.com/eve/forums/a/t...5607348/m/1956095883
You should look for some literature, starts with ''tune to win'' its should answer your questions for while.
So steering ratio is the relation between steering rotation and wheel rotation.
Steering ==> Rack ==> Wheel
From the data you have you should be able to find relation between steering and rack...
If you answer that question, I will help you:
What is the definition of steering ratio and why do you want to know it(please don't say it is because they ask for it in the spec sheet, even if it...
I always love how those single word thread turns out.
BTW, I like that Panoz, the closed version was nice looking too.
cheers,
The Motec 1 Mbit CAN is sometimes an issue with non-Motec product.
If you want the "pro-loging" and more data capacity, you will find out that the ACL is not really more expensive than the ADL...
What is the most powerful bike that use 520 chain?
I assume you have a educationnal license of MatLab. You should have the optimization toolbox which has curve fitting tool. There is recorded webminar on mathworks website.
good luck
The ''anti'' comparision is good. Look at the anti-dive formula, you will see that the brake bias is part of the equation... Ask yourself the following question: Does my inside tire do the same job...
The semis are just long enough for the judges to have a clear idea of who should win design. The weakness of the semis is that it was before the dynamic event. The quality of the semis was that...
What I used to do, is to constraint at the frame suspension point and apply the load at the contact patch trough a rigid part(which replace tire and wheel). Works good for cornering. For...
There is a formula in Milliken's Chassis design book, wich is a function of upright points height and a-arm lenght. Try it in bump and roll... in OptimumK for sure...
I won't tell you to do a free body diagram(but you could), as it can get messy when working with linkage in 3D.
What I suggest you is to do a FEA 3D link model, it allows you to do a first...
If you have packaging problem with pull/push-rod interfering with driveshaft, you can always considers upper a-arm push-rod.The new guys at ETS did it this year and it was pretty clean.
If you...
There is a lot of good SAE papers on tire model for ABS system development that can be use for reference.
Its a pretty interesting and feasable project.
For tire, what you need is a relaxation length model, its an inline model that takes the slip at the wheel and modulates it in function of the tire...