How did you check the CRiP Value with a timing light without starting the engine ?
Regarding, Dwell time of the coils (Your coils are inductive, I am assuming that) you will need a current clamp...
Type: Posts; User: Fulcrum
How did you check the CRiP Value with a timing light without starting the engine ?
Regarding, Dwell time of the coils (Your coils are inductive, I am assuming that) you will need a current clamp...
We used a HUCO 13 8055 (4D0905351) module with our M400.
Its similar to the Bosch 211 Module . As Charlie said you will find it in old Audi A4's, A8's, VW Jetta's and old Passat's.
-
Inder...
If it is as you say , then it must be a starter system problem , the ECU's got nothing to do with it . Check the wiring ,replace the starter motor with a spare if you have one .
-
Inder Sehra...
Does the engine fire ? As in does the process of combustion start and then the engine dies or it just doesnt start. Does the engine crank freely when you remove the plugs ?
-
Inder Sehra
Orion...
@jd
We always try to maintain cleanliness . But still there is always dirt ! . How do you guys clean the engine ? Any tips ? How do you clean the threaded holes ? Gasket maker somehow enters the...
@Drew
Yep we will flush the oil gallery . Should we do the same to the crankshaft ?
Yes we have backup engines .
@Jay
We use a stock crank with no modifications . Actually we did procure a oil...
@Faterooski
We didn't use an oil pressure sensor , just the OEM Oil Pressure Switch . We were running the engine on the stock ECU during the donuts , so I have no record . We used the M400 on the...
Could these bearings have failed due to Overheating of the engine ? We unknowingly ran the engine with a very lean AFR during initial dyno runs . Or could this have been caused due to donuts without...
Could these bearings have failed due to Overheating of the engine ? We unknowingly ran the engine with a very lean AFR during initial dyno runs . Or could this have been caused due to donuts without...
We ran our engine on the M400 . Its pretty easy to setup . Our engine started in the first go ... They have a very good support network ,with webinars etc .We decided which ECU to use on the basis of...
Here is a drum we came up with , got the prototype made which worked well . We carried out a hardness test on the stock piece and got it to be 46-48RC . Material for the final piece is yet to be...