I tried out the pulse steer method to tease out the freq response from a vehicle (again, Lagrangian mechanical vehicle model). results below (gifs @ 120 km/h).
Pulse steer - 10 deg SW over 2.5 sec...
Type: Posts; User: rory.gover
I tried out the pulse steer method to tease out the freq response from a vehicle (again, Lagrangian mechanical vehicle model). results below (gifs @ 120 km/h).
Pulse steer - 10 deg SW over 2.5 sec...
At 5x speed, a chirp steer test conducted at 50 km/h over 20 sec. Red-line connects vehicles CoM to CoM centre of curvature (obviously this tends to +- infinity as the normal acceleration tends to...
Harry,
I believe I linked to the article you are referring to: http://journals.sfu.ca/vte-j/index.php/vte-j/article/view/6.
Erik,
I think we're on much the same page here, though we come at the...
Yeah, r is taken into account. But I guess the point of my input was to highlight that r (chassis rotational velocity) does not equal ay/V, or even an/V. Omega (the rotational velocity of the...
I have always found it interesting that most dual-axis acceleration diagrams (e.g. Cn-Ay etl al) ignore body slip angle rates (see below). While not a huge concern when the diagrams are being used to...
Nb. the output of a GPS signal is lat & long plus noise, which can be converted to relative x & y coords plus noise without adding in additional noise. In order to calculate curvature, you need the...
I've found that using the cousin of a neural network, the genetic algorithm (followed by some gradient based cost minimisation), is a great method for determining the coefficient values for MF 5...
Z's JJ does FSAE-A 2016 track at a 86.7 sec pace (with equiv. R25Bs 10" on 8" wide rims). Fuel consumption is estimated 0.144 L/lap. Concerns here are the 2.0 m^2 to 0.5 m^2 ratio (L/D = -4, okey...
I am aware of a number of teams looking into the relaxation data based on your TTC posts. How far they are towards instituting it into a viable simulation and specification tool, I am unsure.
...
Bill, I thought you might enjoy the below paper as well. Would be relatively easy to get tyre relaxation data from TTC, get Fy and Mz compliance effects in (that data is harder to come by for FSAE...
Build a 150kg car, put 50 kg of tungsten right below the CG. Better yet, have it adjustable so you put it rearward and high (maximise long. load transfer and attempt to lift front wheels) for...
Be aware that a hand-calc is a model as well, and as such, should undergo its own assessment. You are attempting to model some aspect of reality using a algebraic representation. Just because it is...
There is a difference between validation and verification. It's well understood in some areas of engineering, but not properly parsed in other areas.
...
Can't speak to the accuracy of all the content, but: http://journals.sfu.ca/vte-j/index.php/vte-j/article/view/6/11