Search:

Type: Posts; User: Screaming V8

Search: Search took 0.00 seconds.

  1. PM Sent Thanks

    PM Sent

    Thanks
  2. Replies
    2
    Views
    6,141

    Dan, To be honest, I would not spend too much...

    Dan,

    To be honest, I would not spend too much time doing the transient simulation in Solidworks. The Solidworks flow sim is not known to give the best results which is why I (as well as others)...
  3. Check it with a timing light while cranking the...

    Check it with a timing light while cranking the motor. Set the temporary value in motec to 0 deg (TDC) and the crank the motor with a timing light attached. The timing light should show if it is on...
  4. Replies
    1
    Views
    565

    Use this. ...

    Use this. http://www.motec.com/downloads/downloadseminars/ This should help you out on most of the motec stuff you need to set up. What specifically in the setup are you having issues with?
  5. I second the fact that the LSU 4.9s are a lot...

    I second the fact that the LSU 4.9s are a lot easier to kill, we have killed one so far, and I attribute it to being left to heat more than necessary. In motec there are 2 settings, normal and fast...
  6. Replies
    39
    Views
    5,271

    Since fuel economy is becoming more of a factor,...

    Since fuel economy is becoming more of a factor, I would suggest you move to a really small engine. I would say single cylinder since that is what everyone else is doing. I personally would...
  7. Replies
    4
    Views
    684

    Doing a simple search of "Adams tutorial" in this...

    Doing a simple search of "Adams tutorial" in this forum will give you all the information you need.
Results 1 to 7 of 7