Yes, Z can be strident and abrasive; he is also manifestly brilliant and exceedingly well informed. And, yes, Claude can be petulant and self-promotional; he also has extensive experience in various...
Type: Posts; User: Forbes
Yes, Z can be strident and abrasive; he is also manifestly brilliant and exceedingly well informed. And, yes, Claude can be petulant and self-promotional; he also has extensive experience in various...
"Optimum" clearance is 57.367mm, from chassis to ground.
Jonny: Where did that number come from?
Forbes
And then there is the really obvious: Is there enough oil in the tank to start with?
Forbes
This might help: https://msis.jsc.nasa.gov/sections/section03.htm#_3.2_GENERAL_ANTHROPOMETRICS
Forbes
Claude:
You said "A soft spring on a stiff spring is still a stiff spring". I think you meant it the other way around.
Forbes
Luniz, Claude, all: Compare Luniz' upright casting to trabecular bone (see http://study.com/academy/lesson/trabeculae-of-bone-definition-function.html). Deep down, Claude's "aesthetic" and "sexy"...
Matt,
See Costin & Phipps, first full para on p.97 (in 1st ed'n.):
"The loads involved [in a rear upright] are bending in both vertical planes, and torsion from toe-in and toe-out. The best...
Mohammad,
See here: http://www.engineeringtoolbox.com/boiling-point-water-d_926.html
MCoach,
Thanks for the update/correction; I shall amend my records.
Forbes
Test Driver:
E85 is simply a mixture of gasoline and ethanol (ethyl alcohol). According to ASTM D 5798-09b, the proportion of ethanol in the mix can be from 75% to 85%. Many sources point out...
Leif,
Check the stock from which the top hats were made. If it is non-magnetic, then it is certainly neither mild steel nor 4130/4140 - most probably one of the "300 series" stainless steels
Not sure that's correct, Jonny. I believe the pump depends on the surrounding fuel for cooling. (For sure it will cook itself if run dry.) So, might better say: ...any orientation as long as it...
Have you considered talking to each other?
Z says: "the amount of floppiness of the right rear-wheel suggest that maybe the "optimised" wheel-bearings were too optimal?"
Maybe a 'rubber' upright? NC machined uprights invariably have open...
Oh dear - we have lost another Good Guy. Doug was my editor when I began contributing to the sister magazines ‘Open Wheel’ and ‘Stock Car Racing’. Seeking illustrations for my first book, I...
mdavis, Christian
I believe this is the link to the NASA document: http://msis.jsc.nasa.gov/sections/section03.htm#_3.2_GENERAL_ANTHROPOMETRICS
Forbes
Here’s a few suggestions for additions to the list:
Dzik (ed). Aircraft Detail Design Manual (3rd ed'n). Aviation Publications, Appleton, WI., 1977.
Intersecting lines on paper are one thing;...
A water jet cutter will leave a clean edge on both cured laminates of both carbon fibre and Kevlar (no "fuzz"!). Many aerospace composites manufacturers have one. Beware any reciprocating power...