We are using FESTO pneumatic ram's, Yes we do have a intermediate regulator,
We have looked at the data sheet and the best response time we have got out of it was half the quoted value in the data...
Type: Posts; User: Eryk Sokolowski
We are using FESTO pneumatic ram's, Yes we do have a intermediate regulator,
We have looked at the data sheet and the best response time we have got out of it was half the quoted value in the data...
After testing disaster... Drive shaft failure... My guess is that the spark cut was too aggressive and they have seen too much torque reversal...
we have tried two sizes of the cylinder ram... both where very slow...
Did the drilled ports help?
I am trying to use the start line limit strategy function for the acceleration event...
I was wondering has any one managed to implement launch control on the SQ6?
I was wondering if any team out here runs the Cosworth Pectel SQ6 ???
If so give us a shout...
I was wondering if any team out here runs the Cosworth Pectel SQ6 ???
If so give us a shout...
I doubt that we suffer with force (250N+), the problem was the pneumatic ram it took a massive 150~200ms to fully extend even at 180psi (its rated at 120psi)
We changed it to an voice coil...
Yeah but the acceleration event...
around 40% success rate in shifting
Hi,
I am designing a Gearbox Control unit for your car, I am using a micro-controller and electro-penoumatic valves, a pinball air tank and a pneumatic ram.
I got my system working ok but it...
Hi what is your crank reference angle set to?
We had it set to 111'deg, and we had no luck with it, then we set it to 249'deg and it started working....
We also found that running a CAM sensor...
Hi if you are interested please have a look here
13 inch Keizer Wheels 13inch racing wheels magnesium centre pieces
<a...
Hi if you are interested please have a look here
13 inch Keizer Wheels 13inch racing wheels magnesium centre pieces
<a...
Hi,
Does any one know what is the weight of the Yamaha Phazer engine and the weight of the CVT that comes with that engine please???
Thanks
tiger z100 and it was rear wheel drive, they made only one with 4 wheel drive for acceleration record...
they are no longer in production...
already spoke to the company making them...
the...
Joining engines with a common crank is not a solution.
We already looked in to that solution...
I am not looking for mechanical solution but i would like to solve this problem via...
Do you know if there is a way maybe through a microcontroller to make them talk to each other... Maybe by can, I want to have a way of making sure that they run at the same speed, and if not then the...
I want to know is it possible to control separate two engines (singles or maybe twins not bigger than 300cc each) with fuel injection, running with a common intake (20mm restricted) with a common...
I want to know is it possible to control separate two engines (singles or maybe twins not bigger than 300cc each) with fuel injection, running with a common intake (20mm restricted) with a common...