PDA

View Full Version : composite suspension upright


David Wong
11-02-2002, 06:47 AM
can any body know what the
best matrix is for a composite suspension upright?
David Wong
11-02-2002, 06:47 AM
can any body know what the
best matrix is for a composite suspension upright?
Erik C
11-06-2002, 07:33 PM
2/C/2......What do you mean by "matrix"? The type of resin? Number of Plies? Orientation? Material Allowables? What are the loads? The part geometry?

[This message was edited by SpeedRcr on November 07, 2002 at 09:31 AM.]
ben
11-10-2002, 10:53 AM
I would have taken matrix to mean the resin type.

I would say that a high temp epoxy would have been ok. The F1 boys use Bismalamide resin for gearboxes which is really high temp resistant, but I doubt we generate the temperatures to require that?

Ben